Break In Alarm (V-Series)

Break In Alarm (V-Series)

Possible causes

• The IR Beams have been interrupted with the gate in the fully closed position

• Inadvertent activation of the Break-In Alarm feature

​

Solutions

• Clear any obstruction from the path of the beams

• If the lenses are unobstructed, check the wiring between the beams and the controller, as well as between the IRB receiver and transmitter

• Ensure that the beams are properly aligned

• If not required, disable the Break-In Alarm feature in Menu 6: IR Beams


    • Related Articles

    • Break In Alarm (D-Series)

      Possible causes: • The IR PE beams have been interrupted with the gate in the fully closed position • Inadvertent activation of the Break-in Alarm feature Solutions:  • Clear any obstructions from the path of the PE beams • If the lenses are ...

    • Break In Alarm (D-Series)

      Possible causes: • The IR PE beams have been interrupted with the gate in the fully closed position • Inadvertent activation of the Break-in Alarm feature Solutions: • Clear any obstructions from the path of the PE beams • If the lenses are ...

    • Break In Alarm (Sector)

      Possible Causes • The closing loop has been activated while the boom is lowered • Inadvertent activation of the Break-in Alarm feature Solutions • Remove any metal objects from the closing loop • Check the loop wiring and impedance (should typically ...

    • Ambush Alarm ( V-Series)

      Possible causes • The IR beams have been interrupted for the pre-set period of time with the Ambush Alarm feature enabled • Inadvertent activation of the Ambush Alarm feature   Solutions • Clear any obstruction from the path of the beams • If the ...

    • V-Series Electrical Setup and Configuration Guide

      Please find attached the installation manual for the V-Series, which includes the following sections: Required tools and equipment New site installation preparation Operator installation General description Icon used in this guide Electrical setup ...