Ambush Alarm ( V-Series)

Ambush Alarm ( V-Series)

Possible causes

• The IR beams have been interrupted for the pre-set period of time with the Ambush Alarm feature enabled

• Inadvertent activation of the Ambush Alarm feature

 

Solutions

• Clear any obstruction from the path of the beams

• If the lenses are unobstructed, check the wiring between the beams and the controller

• Ensure that the wiring of the beams are correct

• Ensure that the beams are properly aligned

• If not required, disable the Ambush Alarm feature in Menu 6: IR Beams


    • Related Articles

    • V-Series Electrical Setup and Configuration Guide

      Please find attached the installation manual for the V-Series, which includes the following sections: Required tools and equipment New site installation preparation Operator installation General description Icon used in this guide Electrical setup ...

    • Ambush Alarm (D-Series)

      Possible causes: • The IR PE beams have been interrupted for the pre-set period of time with the Ambush Alarm feature enabled • Inadvertent activation of the Ambush Alarm feature Solutions: • Clear any obstruction from the path of the PE beams • If ...

    • Ambush Alarm (D-Series)

      Possible causes: • The IR PE beams have been interrupted for the pre-set period of time with the Ambush Alarm feature enabled • Inadvertent activation of the Ambush Alarm feature Solutions: • Clear any obstruction from the path of the PE beams • If ...

    • Break In Alarm (V-Series)

      Possible causes • The IR Beams have been interrupted with the gate in the fully closed position • Inadvertent activation of the Break-In Alarm feature ​ Solutions • Clear any obstruction from the path of the beams • If the lenses are unobstructed, ...

    • Tamper Alarm wired to Alarm Panel

      Wiring Diagram Tamper Alarm Connected to an Alarm Panel Summary This wiring diagram illustrates how to connect the tamper alarm output of a device to a compatible alarm panel zone/input. The tamper output is used to notify the alarm panel whenever ...