Waiting for Co-Processor / Wait 1 minute or Reset All Power (D-Series)

Waiting for Co-Processor / Wait 1 minute or Reset All Power (D-Series)

Possible causes:
• Poor connection between battery and controller
• The battery voltage is low
• The battery is faulty or disconnected
• Faulty controller

Solutions:
• Ensure that the battery terminals are properly connected on both the controller and battery side
• Measure the battery voltage – it should be no lower than 22V DC for the D10/D10 Turbo when placed under load.

Underload testing:

       -       Disconnect the charger from the battery

            -        Remove the DC motor leads from the DC controller

-      -    Apply the DC motor leads directly to the battery, while measuring the battery voltage

  -       It should not be less than 22V DC under load

• Check for corrosive build-up around the battery terminals. If there is corrosion, replace both the battery and terminals
• Replace the battery
• Ensure that the ‘Mains Present’ icon is solid
• Measure the charger’s output voltage. It should be about  27V for the D10/D10 Turbo
• Replace faulty controller

    • Related Articles

    • Waiting for Co-Processor / Wait 1 minute or Reset All Power (D-Series)

      Possible causes: • Poor connection between battery and controller • The battery voltage is low • The battery is faulty or disconnected • Faulty controller Solutions: • Ensure that the battery terminals are properly connected on both the controller ...

    • Waiting for Co-processor – Wait 1 minute or reset ALL power

      Possible causes • Poor connection between battery and controller • The battery voltage is low or the battery is faulty or disconnected • Faulty controller   Solutions • Ensure that the battery terminals are properly connected • Measure the battery ...

    • Waiting for Co-Processor (Sector)

      Possible Causes • Poor connection between battery and controller • The battery voltage is low or the battery is faulty or disconnected • Faulty controller Solutions • Ensure that the battery terminals are properly connected • Measure the battery ...

    • R3 & R5 Installation Manual

      Please find attached the installation manual for the R3 & R5 swing gate motors, which includes the following sections: Safety instructions Mechanical setup Electric setup General Description Specifications Product identification Required tools and ...

    • D-series controller speed adjustment - PDF file