Centurion Systems Technical Support | Wiring Diagrams | Knowledge Base

Wiring Diagrams
How to wire your tamper alarm on your Smart motor to a G-ultra device to send notifications when tamper is active.
First, connect your wires to the designated unused IO on the G-Ultra and the unused IO on the Smart motor: After completing the wiring, proceed with the following settings on gweb: 1. Navigate to IO settings, select the IO you have wired, and ...
VX Smart and G-Ultra diagram
G-Ultra and Alarm System Diagram
G-Ultra and D5 EVO /D10 Diagram
G-Ultra and Electric Fence Controller Diagram
G-Ultra and Geyser Diagram
G-Ultra to Borehole/Water Pump /Pool Pump/Generator
Ultra & Wizo Maglock and Receiver
Ultra and D5-Smart with Default Settings Diagram
Ultra Connected on D-Series via Wizo Diagram
Ultra to Maglock Diagram
How do I view my network connectivity status on a G-Ultra / Speak Ultra?
How do I change antenna settings on a G-Ultra?
The default setting on the G-Ultra is to use the internal antenna. This should be adequate for most applications where the G-Ultra is located in an area which has average to good network coverage. If the G-Ultra does not receive commands or takes ...