E5 - Current/Voltage Sensor

E5 - Current/Voltage Sensor

The door is too heavy for current force setting, increase the force offset value by using the “+” button in standby mode to F5. Should the error still appear, enable the Full Power (Fp) setting in the menu structure. *Limits Setup will have to be redone.

    • Related Articles

    • 24V AC Low-Voltage SMART Charger Pamphlet

      Please find attached the installation pamphlet for the 24V AC Low-Voltage SMARTt Charge, which includes the following sections: Important safety information Introduction Specifications Product identification Installation and wiring Kindly refer to ...

    • Current Sensor Fault Reading Too High / Current Sensor Fault Reading Too Low (Sector)

      Possible Cause • Controller hardware problem Solution • Replace faulty controller

    • E9 - “DOSS” Sensor Fault

      This error will appear when no feedback is received from the “DOSS” sensor. This could be due to a bad connection between the Sensor and the PCB (Check the 5-Way connector to ensure proper connection). Should the sensor be connected it is possible ...

    • Current Sensor Faulty Reading Too High / Too Low (D-Series)

      Possible causes • Poor/intermittent motor wire connection • Faulty electric motor • Controller hardware problem ​ Solutions • Check connection of motor wires to controller • Replace green motor wire connector • Replace faulty electric motor • Replace ...

    • Current Sensor Faulty Reading Too High / Too Low (D-Series)

      Possible causes • Poor/intermittent motor wire connection • Faulty electric motor • Controller hardware problem Solutions • Check connection of motor wires to controller • Replace green motor wire connector • Replace faulty electric motor • Replace ...