Several factors can lead to the intermittent raising and lowering of the spikes/claws before the pole begins to ascend when the spikes are configured in safe mode. In this mode, the spikes/claws initially lower before the boom starts to raise. ...
If you encounter the “Drive Fault - Motor Drive Failure” error on your D5 EVO, D10, or D10 Turbo controller, the issue may be caused by: Loose or intermittent connections between the motor and controller A damaged H-bridge on the controller, such as ...
Please find attached the installation manual for the D20 SMART, which includes the following sections: Introduction Specifications Product identification Required tools and equipment New site installation preparation Lubrication Operator installation ...
The DOSS is an opto-electronic system that counts pulses to determine the gate’s position and the distance required to reach its respective endstops. Possible Causes of Error: DOSS physically disconnected Poor connection on the DOSS or controller ...