LED output: Green and red LEDs flash in sequence Possible causes: Code has been incorrectly entered three times Inadvertently changed access code when editing settings Possible solutions: Make sure that the code entered is correct Learn the code ...
LED output: Red LED triple-flashes rapidly every four seconds. The tone of the onboard buzzer will also be different from its normal pitch when pressing keys Possible causes: Battery voltage low (SMARTGUARDair) Possible solutions: Replace ...
LED output: Red LED illuminates Possible causes: The access code has not been learned into memory The access code was learned into memory with an access limit set Possible solutions: Learn the access code into memory:
LED output: Green LED illuminates Possible causes: Device has not been paired to a CENTSYS code-hopping receiver (SMARTGUARDair) Possible solutions: Pair the keypad with a CENTSYS code-hopping receiver (SMARTGUARDair) - Place the receiver into ...
If you encounter the “Drive Fault - Motor Drive Failure” error on your D5 EVO, D10, or D10 Turbo controller, the issue may be caused by: Loose or intermittent connections between the motor and controller A damaged H-bridge on the controller, such as ...
Please find attached the installation manual for the D20 SMART, which includes the following sections: Introduction Specifications Product identification Required tools and equipment New site installation preparation Lubrication Operator installation ...
The DOSS is an opto-electronic system that counts pulses to determine the gate’s position and the distance required to reach its respective endstops. Possible Causes of Error: DOSS physically disconnected Poor connection on the DOSS or controller ...