PIRAC (Beam Autoclose) Mode can be activated when using any of the tree operating Modes (standard, open only or revering). To select PIRAC Mode as either on or off, please follow the following Step below:
If you wish to default a D2 Turbo controller board to factory settings, kindly follow the steps below: To perform a complete reset: Step1: Remove power from the unit by disconnecting both the mains supply and one battery terminal Step 2: Press and ...
To add a NOVA rolling code remote control to the onboard receiver and assign a button to any specific function, kindly refer to the video below or follow the steps below the video: Steps on how to learn a new NOVA remote:
To activate the Autoclose feature with a pre-selected time delay, kindly watch the video or refer to the steps at the bottom of the page: Autoclose Step by Step guide:
If you encounter the “Drive Fault - Motor Drive Failure” error on your D5 EVO, D10, or D10 Turbo controller, the issue may be caused by: Loose or intermittent connections between the motor and controller A damaged H-bridge on the controller, such as ...
The DOSS is an opto-electronic system that counts pulses to determine the gate’s position and the distance required to reach its respective endstops. Possible Causes of Error: DOSS physically disconnected Poor connection on the DOSS or controller ...
Please find attached the installation manual for the D20 SMART, which includes the following sections: Introduction Specifications Product identification Required tools and equipment New site installation preparation Lubrication Operator installation ...