Centurion Systems Technical Support | FAQ

FAQ
How to Delete Tag (Tag available) on Solo tag reader
The Delete a Tag will allow you to delete a tag if the tag is present and available. The flow diagram below shows the Delete Tag procedure and described fully below:
How to Delete Tag via Memory Location (Tag not available) on Solo tag reader
The Delete Tag via Memory Location enables you to delete a tag if the tag is lost or not available: The flow diagram below shows the Delete Tag via Memory Location procedure and described fully below:
How to use the quick delete option to delete ALL tags on the Solo reader
The quick delete feature will allow all tags that is programmed to be deleted keeping the configuration settings: The flow diagram below shows the quick delete all procedure and described fully below:
How to use the quick learn option to add a new tag for a solo tag reader existing installation.
The quick learn feature enables new tags to be entered very quickly into the system on a existing installation The flow diagram below shows the quick learn procedure and described fully below:
How to use the quick learn option to add a new tag for a solo tag reader new installation.
The quick learn feature enables new tags to be entered very quickly into the system if this is a new installation or if the tag reader was defaulted. The flow diagram below shows the quick learn procedure and described fully below:

Popular Articles
Drive Fault - Motor Drive Failure (D-Series)
How to troubleshoot a drive fault failure on your D5 EVO, D10 or D10 Turbo Centurion Systems gate motor The error "Drive Fault - Motor Drive Failure" on your D5 EVO, D10 and D10 Turbo controller can be caused by: • Intermittent or loose connection ...
D20-SMART Installation Manual
Please find attached the installation manual for the D20 SMART, which includes the following sections: Introduction Specifications Product identification Required tools and equipment New site installation preparation Lubrication Operator installation ...
Version 1 smart controllers ONLY - 220V Light diagram
How do I add a secondary user on G-WEB?
Prerequisite check: Ensure that a user who will be added as secondary on the device, has an existing G-WEB profile. The below steps can then be followed to add a secondary user. Scroll to the right on your "my devices" page and select secondary user ...
DOSS Fault - Doss Fault - Disconnected (D-Series)
The DOSS is an opto-electronic system that counts pulses in order to determine the position of the gate and the distance that it needs to travel to its respective Endstops. Possible causes • DOSS physically disconnected • Poor connection on DOSS or ...

Centurion Systems Technical Support | FAQ | Knowledge Base