XTRAC Does Not Function at All

XTRAC Does Not Function at All

Possible causes: 

Low battery voltage

XTrac not engaged properly

Holiday lock mode evoked

 

 

Possible solutions: 

Check that the power cord is plugged in and turned on

Check the battery voltage

Check that the XTrac is engaged

Holiday Lockout mode evoked:

To get the operator out of holiday lock, press and hold button no three until the courtesy lamp flashes twice or default the PCB by remove all power, switch on all the dip switch and press and hold the both the learn and run button the led will flash rapidly


    • Related Articles

    • XTRAC Does Not Function From Remote

      Possible causes:  Xtrac is not running due to holiday lock mode or due to low battery Transmitters was deleted on the on-board receiver Transmitter battery is low   Possible solutions:  Check function of XTrac by operating from ‘Run’ button Check ...

    • XTrac Installation Manual

      Please find attached the installation manual for the XTrac garage door operator which includes the following sections: General description Icons used in this manual Technical Specifications Product identification Required tools and equipment Site ...

    • How to Program NOVA Remotes on the Onboard Receiver of an XTrac Garage Operator

      Follow the steps below to program a remote for your XTrac motor. There are various functions available, depending on which button you select during the programming process. Functions Available for Remote Programming: Button 1: Open/Close - This ...

    • XTRAC Runs Very Slowly

      Possible causes:  Speed control setting may be too low Low battery voltage Door not balanced   Possible solutions:  Speed control setting may be too low - increase speed setting Batteries are running low - check that charger is charging Garage door ...

    • 2 Wire Beams (XTRAC)