Set Up Fail No Endstops Found (Sector)

Set Up Fail No Endstops Found (Sector)

Possible Causes
• DOSS is faulty or disconnected
• The gearbox is slipping

Solutions
• Replace faulty DOSS or reconnect the unplugged connections
• Contact an authorised agent to service the gearbox
• Tighten the drive-arm or contact an authorised agent

    • Related Articles

    • Set Up Fail: No End Stops Found (D-Series)

      Possible Causes • Mechanical Endstops have not been installed • Oil in DOSS chamber • DOSS faulty or disconnected • Electric fence contact preventing gate from reaching fully closed position • Faulty electrical motor Solutions • Install physical End ...

    • Sector 2 Installation Manual

      Please find attached the installation manual for the Sector 2 boom barrier, which includes the following sections: Glossary of terms Product identification Physical installation Onsite electrical wiring Basic controller setup Installation handover ...

    • No Limits Set (Sector)

      This error will display if the End-of-travel limits have not been established. Solution • Set the gate travel limits by accessing the Setting Limits menu (Menu1: Setting Limits) and following the onscreen prompts or steps supplied below: The ...

    • Set Up Fail: Inconsistent End Stops (Sector)

      Possible Cause • One or both Endstops are moving • The gearbox is slipping Solution • Use a Phillips screwdriver to sufficiently tighten the open and closed Endstops. They should not move at all when subjected to force • Tighten the drive-arm or ...

    • Set Up Fail: No End Stops Found (D-Series)

      Possible Causes • Mechanical Endstops have not been installed • DOSS faulty or disconnected • Electric fence contact preventing gate from reaching fully closed position • Faulty electrical motor Solutions • Install physical End stops in order to ...