Set Up Fail: No End Stops Found (D-Series)

Set Up Fail: No End Stops Found (D-Series)

Possible Causes
• Mechanical Endstops have not been installed
• DOSS faulty or disconnected
• Electric fence contact preventing gate from reaching fully closed position
• Faulty electrical motor

Solutions
• Install physical End stops in order to induce the stall needed to stop the motor
• Ensure that the harness is connected on both the controller and DOSS side
• Place an endstop approximately 100mm before the fully closed position and perform setup procedure
• Disconnect the motor wires from the controller and place them directly on the battery terminals to check whether the motor runs. If not, replace the electric motor.

    • Related Articles

    • Set Up Fail: No End Stops Found (D-Series)

      Possible Causes • Mechanical Endstops have not been installed • Oil in DOSS chamber • DOSS faulty or disconnected • Electric fence contact preventing gate from reaching fully closed position • Faulty electrical motor Solutions • Install physical End ...

    • Set Up Fail: Inconsistent End Stops (D-Series)

      Possible Causes • Mechanical Endstops are not securely fitted • Poor meshing between rack and pinion due to excessive gap, missing teeth, etc. • Faulty DOSS sensor • Electric fence contact preventing gate from reaching fully closed position Solutions ...

    • Set Up Fail: Inconsistent End Stops (D-Series)

      Possible Causes • Mechanical Endstops are not securely fitted • Poor meshing between rack and pinion due to excessive gap, missing teeth, etc. • Faulty DOSS sensor • Electric fence contact preventing gate from reaching fully closed position Solutions ...

    • Set Up Fail: Inconsistent End Stops (Sector)

      Possible Cause • One or both Endstops are moving • The gearbox is slipping Solution • Use a Phillips screwdriver to sufficiently tighten the open and closed Endstops. They should not move at all when subjected to force • Tighten the drive-arm or ...

    • No Limits Set (D-Series)

      Possible cause: • The End-of-Travel limits have not been established Solution: • Set the gate travel limits by accessing the Setting Limits menu (Menu 1: Setting Limits) and following the onscreen prompts (Steps attached)