Set Up Fail: Inconsistent End Stops (D-Series)

• Related Articles

• Set Up Fail: No End Stops Found (D-Series)

  Possible Causes • Mechanical Endstops have not been installed • Oil in DOSS chamber • DOSS faulty or disconnected • Electric fence contact preventing gate from reaching fully closed position • Faulty electrical motor Solutions • Install physical End ...

• Set Up Fail: No End Stops Found (D-Series)

  Possible Causes • Mechanical Endstops have not been installed • DOSS faulty or disconnected • Electric fence contact preventing gate from reaching fully closed position • Faulty electrical motor Solutions • Install physical End stops in order to ...

• Set Up Fail: Inconsistent End Stops (D-Series)

  Possible Causes • Mechanical Endstops are not securely fitted • Poor meshing between rack and pinion due to excessive gap, missing teeth, etc. • Faulty DOSS sensor • Electric fence contact preventing gate from reaching fully closed position Solutions ...

• Set Up Fail: Inconsistent End Stops (Sector)

  Possible Cause • One or both Endstops are moving • The gearbox is slipping Solution • Use a Phillips screwdriver to sufficiently tighten the open and closed Endstops. They should not move at all when subjected to force • Tighten the drive-arm or ...

• No Limits Set (D-Series)

  Possible cause: • The End-of-Travel limits have not been established Solution: • Set the gate travel limits by accessing the Setting Limits menu (Menu 1: Setting Limits) and following the onscreen prompts (Steps attached)