How to reset the controller to factory default on the D5 EVO and D10

Should you desire to restore the D5 EVO or D10 controller to factory default, please follow the steps outlined below:

Resetting the controller to factory default

1. Press and hold the oblong button (located between the two arrows) for about 3 seconds.
   
2. A screen labeled "Setting Limits" will appear; use the DOWN arrow to navigate ten times until "General Settings" is displayed.
   
3. Press and release the oblong button once (do not hold it).
   
4. Scroll with either the up/down arrow buttons to go to "Reset Options."
   
5. Press and release the oblong button.
   
6. Press the oblong button once to choose factory defaults.
   
7. "Reset to factory settings" will be shown; press the arrow button to select "yes."
   
8. Press the oblong button once to accept; the board should now be reset to factory default settings 
   

Please see above steps illustrated in the video below: 

• Related Articles

• How to default your RDO11 garage operator controller board

  If you wish to default a RDO11 garage operator controller board to factory settings, kindly follow the steps below: 1. Open the courtesy light cover, and remove the control box cover to expose the control board. 2. Remove all power from the control ...

• Resetting the controller to factory default on the D-Series - PDF file

• Resetting the controller to factory default on the D-Series - PDF file

• How to default a D2 Turbo controller board to factory settings

  If you wish to default a D2 Turbo controller board to factory settings, kindly follow the steps below: To perform a complete reset: Step1: Remove power from the unit by disconnecting both the mains supply and one battery terminal Step 2: Press and ...

• D5 Evo Mechanical Installation Guide