Motor Pushes in One Direction/”Jumping” on Gear During Setup

Motor Pushes in One Direction/”Jumping” on Gear During Setup

Possible causes: 

The gap between the rack and the pinion is too large

​

Possible solutions: 

Ensure that the gap between the rack and the pinion is no greater than 3mm. Due to the considerable force exerted by the D2 Turbo, it is sometimes necessary to apply additional weight to the gate during the initial setup


    • Related Articles

    • V-Series Electrical Setup and Configuration Guide

      Please find attached the installation manual for the V-Series, which includes the following sections: Required tools and equipment New site installation preparation Operator installation General description Icon used in this guide Electrical setup ...

    • How to setup the limits on a R3/R5 Swing gate motor

      If you wish to setup the limits on a new or existing R3/R5 gate motor, kindly follow the steps supplied below: Step 1 - Set the gate origin: • Release the manual override by screwing the manual release mechanism fully clockwise and close the gate(s): ...

    • Setup Failed - See Manual

      Possible causes • Operator gearbox disengaged • ’DBL’ has been selected for a single-leaf installation • Loose connection on the sensor terminals • Installation dimensions are not according to specification • Crimped or cut cables • Intermittent ...

    • How to Set Up Limits on a V-Series (VX) SMART Swing Gate Motor

      To set up or reset the limits on your V-Series SMART Swing Gates, please follow the steps below: Limits steps carried in the video below: Follow the steps below to set or reset the limits on your V-Series SMART Swing Gate: Download the MyCentsys Pro ...

    • SDO5 SMART+ Manual

      Please find attached the installation manual for the SDO5 SMART+ garage door operator, which includes the following sections: INTRODUCTION PRODUCT SPECIFICATIONS PRODUCT IDENTIFICATION REQUIRED TOOLS AND EQUIPMENT PREPARATION OF SITE OPERATOR ...