How to Power Up the RDO Digital Garage Operator for the First Time and How to Setup the Operator

Kindly find the steps on how to power up the RDO Digital for the first time and setting up the operator limits detailed below:

Kindly find the video tutorial with steps blow:

1. Powering Up:
   When the PCB (Controller) is powered on for the first time, the segment display will show "DL" (Door Left). This indicates that the system is asking you to select the side of the door where the motor is installed.
   
   
2. Select Motor Side:
   
   • Press the + or – button to choose the motor side:
     
     • "DL" (Left of the door)
     • "DR" (Right of the door)
   • If the motor is installed on the right side of the door, select "DR."
     
     
3. Setting the Close Limit (CL):
   
   • After selecting "DR," the display will prompt for the "CL" (Close Limit).
   • Press and hold the – button to move the door to the fully closed position.
   • Once the door reaches the closed position, release the – button and press the Confirm button.
   • The door will perform a short up-and-down movement to verify the closed position.
     
     
4. Setting the Open Limit (OL):
   
   • Next, the display will show "OL" (Open Limit).
   • Press and hold the + button to move the door to the fully open position.
   • Once the door reaches the open position, release the + button and press the Confirm button.
   • The door will perform a short down-and-up movement to verify the open position.
     
     
5. Force Learn (FL):
   
   • The display will now show "FL" (Force Learn).
   • Press and release the Confirm button to initiate force learning.
   • The door will automatically run to the closed position and then open again to check the limits.
     
     
6. Completion:
   
   • After the door reaches the open position, the display will show a "." (dot), indicating that the limit setup is complete.
     

Your RDO Digital Garage Operator is ready for operation.   Should you need further assistance or more information, please do not hesitate to reach out to our support gurus. You may start a chat session by visiting with us on WhatsApp at +27 83 650 4010.

• Related Articles

• CENTURION RDO-Digital - Garage Door Operator Manaul

  Please find attached the installation manual for the RDO-Digital installation manual, which includes the following sections: Important safety instructions Specifications Product identification New site installation preparation Operator installation ...

• Low Power - SDO4 Smart

  Unable to Set Limits – Low Power Supply (SDO4 Smart) Summary This error occurs when the operator detects insufficient power during a system health check, preventing the limit setup process. The most common cause is low or unstable battery voltage, ...

• How to default your RDO11 garage operator controller board: Video Tutorial and Step-by-Step instructions.

  If you wish to default a RDO11 garage operator controller board to factory settings, kindly follow the steps below: Watch the tutorial below or scroll down for the step-by-step instructions. 1. Open the courtesy light cover, and remove the control ...

• How to Check and Understand Spring Tension on Your Garage Door

  The spring tension in your garage door is critical to the smooth and safe operation of the system. Springs are responsible for balancing the weight of the door, making it easier for the motor to lift and lower it. Incorrect tension can cause: ? ...

• How to Factory Reset the PCB (Controller) on the RDO Digital garage Operator

  To Perform a Factory Reset on the RDO Digital PCB (Controller), kindly follow the steps below: Remove the Console Cover Start by removing the console cover to access the PCB (Controller). Locate the Blue Connector On the left side of the PCB, ...