How to Factory Reset the PCB (Controller) on the RDO Digital garage Operator

To Perform a Factory Reset on the RDO Digital PCB (Controller), kindly follow the steps below:

1. Remove the Console Cover
   Start by removing the console cover to access the PCB (Controller).

2. Locate the Blue Connector
   On the left side of the PCB, identify the blue connector attached to a red and black wire.

3. Disconnect the Blue Connector
   Carefully unplug the blue connector from the PCB. This will disconnect the power to the board.

4. Press and Hold the Learn Button
   With the PCB powered off, press and hold the "Learn" button.

5. Reconnect the Blue Connector
   While holding the "Learn" button, reconnect the blue connector to the PCB.

6. Wait for "FR" to Appear on the Display
   The segment display will show "FR," signaling that the factory reset process has begun.

7. Release the Learn Button
   Once "FR" appears on the display, release the "Learn" button.

8. Final Display
   The PCB will complete the factory reset, display the current firmware version, and then return to the Limit Setup screen.

Follow the steps above to successfully reset the PCB to its factory settings.    Should you need further assistance or more information, please do not hesitate to reach out to our support gurus. You may start a chat session by visiting with us on WhatsApp at +27 83 650 4010

• Related Articles

• CENTURION RDO-Digital - Garage Door Operator Manaul

  Please find attached the installation manual for the RDO-Digital installation manual, which includes the following sections: Important safety instructions Specifications Product identification New site installation preparation Operator installation ...

• How to default your RDO11 garage operator controller board: Video Tutorial and Step-by-Step instructions.

  If you wish to default a RDO11 garage operator controller board to factory settings, kindly follow the steps below: Watch the tutorial below or scroll down for the step-by-step instructions. 1. Open the courtesy light cover, and remove the control ...

• How to default your X-Trac garage operator controller board: Video Tutorial and Step-by-Step instructions.

  If you wish to default a X-Trac garage operator controller board to factory settings, kindly follow the steps below: Watch the tutorial below or scroll down for the step-by-step instructions. 1. Open the courtesy light cover, and remove the control ...

• How to Power Up the RDO Digital Garage Operator for the First Time and How to Setup the Operator

  Kindly find the steps on how to power up the RDO Digital for the first time and setting up the operator limits detailed below: Kindly find the video tutorial with steps blow: Powering Up: When the PCB (Controller) is powered on for the first time, ...

• How to Learn Remotes for the Run Function on RDO Digital Garage Operator

  Learning remotes for the run function on the RDO Digital allows you to control the garage door operator remotely, providing convenience and ease of use. It enables users to open and close the garage door from a distance, ensuring smooth operation ...