How to Disable/Enable Auto Close on CP75 controller – Step-by-Step Guide

How to Disable/Enable Auto Close on CP75 controller – Step-by-Step Guide

Notes
If you wish to to  Disable/Enable Auto Close on CP75 controller, kindly follow the steps below:
Info
Step 1 - Preparation
1. Power Off :
o   Switch off the power to the unit completely. Battery and Power Supply
2. Fit Set Link (Bridge):
o Fit the set link (bridge) onto the correct pins on the PCB.

Disable Auto Close
1. Power On:
o Switch the power back on.
o The L2 light will turn on permanently.
2. First Test Button Press
o Press the test button and watch L1.
o Release after 2 flashes on L1.
3. Second Test Button Press
o Press and hold the test button again.
o Watch the status light.
o Release after 2 flashes. ✅ Auto Close is now OFF.

Enable Auto Close
1. Repeat steps 1–2 above (Power off, fit set link, power on, release after 2 flashes on L1).
2. Second Test Button Press
o Press and hold the test button again.
o Watch the status light.
o Release after 1 flash. ✅ Auto Close is now ON.
AlertShould you need further assistance or more information, please do not hesitate to reach out to our support gurus via our Centurion Systems WhatsApp service (0836504010).