How to Program NOVA Remotes on the Onboard Receiver of an XTrac Garage Operator

How to Program NOVA Remotes on the Onboard Receiver of an XTrac Garage Operator

Notes
Follow the steps below to program a remote for your XTrac motor. There are various functions available, depending on which button you select during the programming process.

Idea

Functions Available for Remote Programming:

  • Button 1: Open/Close - This function is associated with opening and closing the door only.
  • Button 2: Light - Learning a button to Function Two will enable that button to switch the courtesy light
  • on and off.
  • Button 3: Holiday Lock - Electronically lock the controller for use. In other words, no transmitters or inputs, other than those learned for holiday lockout mode, will be able to trigger the operator.
  • Button 4: Autoclose Override - This function will allow the associated button to override the autoclose function if it has been selected, resulting in the door staying open.
Info

Step-by-Step Programming Instructions:

  1. Press the 'Learn' Button:

    • Press the button once for Open/Close.
    • Press it twice for Light.
    • Press it three times for Holiday Lock.
    • Press it four times for Autoclose Override.

  2. Confirm Function Selection:

    • The LED indicator will flash the number of times the button was pressed every two seconds, indicating the selected function.

  3. Learn the Remote or Wall Switch:

    • Take the remote control or wall switch you want to program, then press and hold the desired button for three seconds.
    • The onboard buzzer will emit one long beep followed by one short beep if the button has been successfully learned.
    • Proceed this way to learn any other transmitters into the system to operate the requested function
Once done with the learning procedure, wait 10 seconds to exit programming mode.
Quote

Your remotes will not be ready for operation.