Gate Does not Run, but Relay Energises When Unit is Activated

• Related Articles

• During Limit Set Up, Gate Doesn't Run but Relay Energises. (Status Flashes 5 Times And L2 Comes on)

  Possible causes:  Battery low or disconnected  DOSS faulty or disconnected Loose motor wires or blown motor fuse Loose battery connection  Possible solutions:  Check that battery voltage stay above 11.0v while gate is running Check motor wires are ...

• How to Troubleshoot a CP80 D5 or D3 Gate Motor When the Gate Does Not Run But the Relay Energise

  When you activate the gate motor via a remote or any trigger device, and the relays energize but the gate does not move, please refer to the possible causes and solutions below: Possible Causes: Faulty motor circuit Faulty motor relay / FET Motor ...

• How to Troubleshoot a CP80 D5 or D3 Gate Motor When the Gate Does Not Run and the Relay does NOT Energise

  When you activate the gate motor using a remote or any trigger device, but the gate does not move, consider the following possible causes and solutions: Possible Causes: Still in programming mode Safety LED's are active Latching input Battery ...

• How to Disable the Run/Test Button on Your D-Series Gate Motor - Video

  Kindly refer to the video below that carries the steps on how How to Disable the Run/Test Button on Your D-Series Gate Motor:

• Photon Infrared Gate Safety Beams User Guide

  Please find attached the User Guide for the Photon Infrared Gate Safety Beams, which includes the following sections: Introduction Safety instructions Icons used in the guide Operation Technical specification Installation Kindly refer to the guide ...