E1 - Safety Beams Active

E1 - Safety Beams Active

If this error appears the safety beams are obstructed, this will display as soon as the beams are obstructed (broken). Should the safety beams not be unobstructed check the alignment, wiring and jumper (on 2W for two wire and 4W for four wire). Should there be no beams fitted and this error appears, turn the safety beams off in the SB menu.

    • Related Articles

    • SDO5 SMART+ I5 Safety Beams Wiring Guide

      Wiring Diagram Wiring I5 Safety Beams to the SDO5 SMART+ Summary A step-by-step guide explaining how to correctly wire I5 Safety Beams to an SDO5 SMART+ garage door operator, ensuring safe operation and reliable obstacle detection. Note: Ensure that ...

    • How to Troubleshoot a Beam Active Error on a D5 EVO

      If you find yourself unable to close or open your gate, and your controller LCD screen is displaying a ""Beam Active"" error, kindly refer to the below possible causes for this error to appear: Symptom: -When you press your remote or any trigger ...

    • Photon Infrared Gate Safety Beams User Guide

      Please find attached the User Guide for the Photon Infrared Gate Safety Beams, which includes the following sections: Introduction Safety instructions Icons used in the guide Operation Technical specification Installation Kindly refer to the guide ...

    • I5 Infrared Gate Safety Beams User Guide

      Please find attached the User Guide for the I5 Infrared Gate Safety Beams, which includes the following sections: Introduction Safety instructions Icons used in the guide Operation Technical specification Installation Kindly refer to the guide below ...

    • Photon SMART Infrared Gate Safety Beams User Guide