Possible causes:
Mains Power Not Turned on or Door is Obstructed
Possible solutions:
Turn on Mains Power or Remove Obstruction
Related Articles
E3 - Door Unbalanced
This error will appear if the Door Service Monitor detects that the door is not balanced and the door should be serviced. It is recommended to re-tension the balancing springs.
Door Operates from Drive Unit, but Not From Hand Transmitter
Possible causes: Transmitter is damaged or broken Transmitter Code has not been programmed into the receiver Receiver antenna wire not straight Battery flat. Possible solutions: Try to operate the door with an alternative transmitter Locate ...
Door is Locked or Motor Jammed
Possible causes: Mechanical door lock has been engaged Possible solutions: Unlock door Inspect door and remove jam
Door Stops Before Reaching Fully Open Position
Possible causes: Physical obstruction Incorrect spring balance or incorrect door balance Low obstruction force setting Incorrect limit adjustment Possible solutions: Disengage XTrac from door and check for obstructions Disengage XTrac from door ...
Door Stops & Reverses Before Reaching Fully Closed Position
Possible causes: Physical obstruction Incorrect spring balance or incorrect door balance Low obstruction force setting Incorrect limit adjustment Possible solutions: Disengage XTrac from door and check for obstructions Disengage XTrac from door ...