Aux Overload (D-Series)

Possible causes

• The maximum current that should be drawn by a D10 controller is 300mA (momentarily); 200mA (continuous)

• This error indication is displayed in the event of excess current being drawn

• Too many auxiliary components connected to 12V auxiliary output

• One specific auxiliary device that is faulty, typically having a short circuit

• Charging voltage significantly higher than 28V DC due to faulty charger or controller

Solutions

• Ensure that the battery charging voltage is no higher than 28V DC.

• Disconnect and reconnect auxiliary component one by one in order to isolate the problem

Related Articles
Aux Overload (Sector)
Possible Causes This error indication is displayed in the event of excess current being drawn. • Incorrect spring orientation • Incorrect spring tension • Too many auxiliary components connected to 12V auxiliary output • The maximum current that ...
D-series controller speed adjustment - PDF file
D-series controller speed adjustment - PDF file
Drive Fault - Motor Drive Failure (D-Series)
Possible causes: • Intermittent or loose connection between motor and controller • The H-bridge on the controller is damaged, possibly a blown FET • The electric motor is faulty or has been disconnected Solutions: • Check drive connections • Check ...
Setting gate limits on the D-series controller - Video
Kindly refer to the video below that carries the steps on how to set gate limits on the D-series controller:

Related Articles